LaCrosse V6-3.6L VIN 7 (2006)
4.
Install the pressure hose fitting (1) to the steering gear.
Tighten
Fitting to 27 Nm (20 lb ft).
Important: The end of the new pressure hose that attaches to the power steering pump has a quick connect feature. This feature is only for the
installation of a new pressure hose to a new hose connector.
5. Push the pressure hose (1) into the hose connector in order to install the hose to the power steering pump.
6. Install the right side engine mount/bracket assembly.
7. Lower the powertrain into position while aligning the right side engine mount and left side transmission mount into position.
8. Clip the pressure hose retaining clips into place.
9. Install the right side engine mount lower nuts.
10. Install the left side transmission mount lower nuts.
11. Install the steering gear heat shield.
12. Install the right front engine splash shield.
13. Install the right front tire and wheel assembly.
