LaCrosse V6-3.6L VIN 7 (2006)
Power Steering Pump: Service and Repair
Power Steering Pump Replacement
Power Steering Pump Replacement (LY7)
Removal Procedure
1. Place a drain pan under the vehicle.
2. Remove the drive belt.
3. Turn the steering wheel to the right in order to allow clearance to remove the pump.
4. Raise and support the vehicle.
5. Remove the right front tire and wheel.
6. Disconnect the power steering pump inlet hose from the power steering pump.
7. Disconnect the power steering pressure hose from the power steering pump.
8. Remove the power steering pump mounting bolts.
9. Remove the power steering pump from the engine.
10. Cap the power steering pump fittings and hoses to prevent contamination.
11. Remove the power steering pump pulley.
Installation Procedure
1. Install the power steering pump pulley.
2. Remove the caps from the power steering pump fittings and hoses.
3. Position the power steering pump (1) on the engine.
4. Install the power steering pump mounting bolts. HAND TIGHTEN ONLY.
5. Notice: Refer to Fastener Notice in Service Precautions.
