LaCrosse V6-3.6L VIN 7 (2006)
4. Loosen the bolts and separate the dies.
5. Check swaged ring (2) for any lip deformities. If present, place the ring (2) back into the J 41048 making sure the ring covers the whole swaging
area. If necessary, re-swage the ring.
6. Important: Place a towel in the vise before inserting the halfshaft.
For eared clamp installation, mount the halfshaft into a vise.
7. Install the new eared clamp (2) on the neck of the seal. Do not crimp.
8. Slide the seal (1) onto the halfshaft bar and position the neck of the seal in the seal groove (3) on the bar.
