LaCrosse V6-3.8L (2009)
8. Remove the 3 park brake pedal assembly nuts from the body studs.
9. Remove the retaining clip and disconnect the cable from the clevis.
10. Compress the locking tabs on the cable conduit to release the cable from the bracket on the pedal assembly.
11. Remove the park brake pedal assembly.
Installation Procedure
1. Install the park brake assembly onto the body mounting studs.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the 3 park brake pedal assembly nuts and tighten to 25 Nm (18 lb ft).
3. Install the front park brake cable into the bracket on the park brake pedal assembly.
4. Insert the cable button into the clevis and install the retaining clip.
5. Connect the electrical connector to the park brake switch.
6. Reposition the carpet properly.
7. Install the left side front carpet retainers and the lower center pillar trim panel on the left side. Refer to Center Pillar Lower Trim Panel
Replacement (See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair).
