LaCrosse V6-3.8L (2009)
14. Install the A/C compressor bracket and the A/C compressor bracket bolts.
Tighten the A/C compressor bracket bolts to 50 Nm (37 lb ft).
15. Install the A/C compressor and the A/C compressor nuts.
Tighten the A/C compressor nuts to 30 Nm (22 lb ft).
16. Install the power steering oil cooler pipe brackets to the frame.
17. Install the right engine splash shield.
18. Install the right front tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
19. Lower the vehicle.
20. Remove the engine support fixture.
21. Install the right and left engine mount struts. Refer to Engine Mount Strut Replacement - Right Side (See: ) and Engine Mount Strut Replacement
- Left Side (See: ).
22. Install the air inlet duct to the throttle body.
23. Connect the intake air temperature (IAT) sensor electrical connector.
24. Install the drive belt. Refer to Drive Belt Replacement (L26) (See: Drive Belt/Service and Repair).
25. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (See: Powertrain Management/Fuel Delivery and Air
Induction/Fuel Injector/Service and Repair/Removal and Replacement/Fuel Injector Sight Shield Replacement).
26. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (L26) (See: Starting and
Charging/Battery/Battery Cable/Service and Repair)Battery Negative Cable Disconnection and Connection (LS4) (See: Starting and
Charging/Battery/Battery Cable/Service and Repair).
