LaCrosse V6-3.8L (2009)
Oil Level Sensor: Service and Repair
Engine Oil Level Sensor and/or Switch Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
2. Remove the engine oil drain plug in order to drain the engine oil.
3. Disconnect the oil level sensor electrical connector.
4. Remove the engine oil level sensor from the oil pan.
Installation Procedure
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
1. Install the engine oil level sensor to the oil pan.
Tighten the sensor to 20 Nm (15 lb ft).
2. Connect the oil level sensor electrical connector.