LaCrosse V6-3.8L (2009)
6. Install the CPA to the SDM connector.
7. Position the carpet to cover the SDM.
8. Reposition the front and rear door weather-strips as required.
9. Install the center pillar, lower trim panel. Refer to Center Pillar Lower Trim Panel Replacement (See: Body and Frame/Interior Moulding /
Trim/Trim Panel/Service and Repair).
10. Install the right insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side (See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Service and Repair).
11. Install the passenger front seat. Refer to Front Seat Replacement - Bucket (See: Body and Frame/Seats/Service and Repair/Front Seat
Replacement - Bucket).
12. Enable the SIR system. Refer to SIR Disabling and Enabling (See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air
Bag(s) Arming and Disarming/Service and Repair).
13. If you replaced the SDM, Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for programming and
setup information.