LaCrosse V6-3.8L (2009)
7. Remove the connector position assurance (CPA) (3) from the side impact sensor connector (4).
8. Disconnect the side impact sensor connector (4).
9. Remove the sensor from the vehicle.
Installation Procedure
1. Remove any dirt, grease, or other impurities from the mounting surface.
2. Position the inflatable restraint side impact sensor by the door.
3. Connect the side impact sensor connector (4).
4. Install the CPA (3) to the side impact sensor connector.
5. Install the side impact sensor (1) to the door (4).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
6. Tightening the side impact sensor bolts (2).
Tighten the bolts to 10 Nm (89 lb in).
7. Install the water deflector to the door.
8. Enable the SIR system. Refer to SIR Disabling and Enabling (See: Air Bag(s) Arming and Disarming/Service and Repair).
