LaCrosse V6-3.8L (2009)
1. Install the wheel bearing/hub with the splash shield as noted during removal.
Warning
These fasteners MUST be replaced with new fasteners anytime they become loose or are removed. Failure to replace these fasteners after they become
loose or are removed may cause loss of vehicle control and personal injury.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install NEW wheel bearing/hub bolts.
Tighten the NEW wheel bearing/hub bolts to 130 Nm (96 lb ft).
3. Install the brake rotor and caliper. Refer to Front Brake Rotor Replacement (See: Brakes and Traction Control/Disc Brake System/Brake
Rotor/Disc/Service and Repair/Removal and Replacement/Front Brake Rotor Replacement).
4. Install the front wheel drive shaft nut. Insert a drift on a flat-bladed tool into caliper and rotor to prevent the rotor from turning.
Tighten the front wheel drive shaft nut to 160 Nm (118 lb ft).
Note: Ensure that the connector clip engages the bracket properly.
5. Install the wheel speed sensor electrical connector to the bracket, if equipped.
6. Connect the wheel speed sensor electrical connector (2), if equipped.
7. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
8. Lower the vehicle.
