LaCrosse V6-3.8L VIN 2 (2005)
16. Secure the lock cylinder in the J 41340.
1. Inspect that the spring retainer is facing up and positioned directly under the punch slots.
2. Push the lock cylinder into the J 41340 until butted with the lock cylinder bezel.
3. Tighten the J 41340 holding screw.
17. Stake the bezel end of the spring retainer:
1. Hold the flat side of the punch, part of J 41340, squarely against the face of the lock cylinder bezel.
2. Stake the lock cylinder metal over the spring retainer prong.
18. Stake the opposite end of the spring retainer:
1. Remove the J 41340 punch.
2. Rotate the J 41340 punch 180 degrees.
3. Hold the J 41340 punch squarely against the end of the punch slot on J 41340.
4. Stake the lock cylinder metal over the spring retainer prong.
19. Loosen the J 41340 holding screw.
20. Remove the lock cylinder from the J 41340.
21. Inspect that the spring retainer is properly staked. Repeat staking as needed.
22. Lubricate the lock cylinder core retainer slot.
23. Insert the following parts into the lock cylinder core retainer slot:
-
The lock cylinder retainer spring (2)
-
The lock cylinder retainer (3)
24. Lubricate the following parts with GM P/N 12345996 or equivalent:
IMPORTANT: Use a paste type grease, not a spray, for the following step.
