LaCrosse V6-3.8L VIN 2 (2005)
20. Disconnect the seat belt pretensioner-left connector from vehicle wiring harness connector (1).
21. Remove the left rear panel.
22. Remove the CPA from the left/driver roof rail module connector (2).
23. Disconnect the left roof rail module wiring harness yellow connector (2) from the left roof rail module (3).
ENABLING PROCEDURE
1. Remove the key from the ignition switch.
2. When enabling the right/passenger seat belt pretensioner proceed to step 3, if the SDM needs enabling then use entire procedure.
3. Connect the seat belt pretensioner-right connector to the vehicle wiring harness connector (1).
4. Install the CPA to the seat belt pretensioner connector (1).
