LaCrosse V6-3.8L VIN 2 (2005)
3. Install the coolant heater so the element is at the 9 o'clock position (2).
4. Tighten the coolant heater bolt until both locking wings draw tight against the inner wall of the engine block.
Tighten the bolt to 2 Nm (17 inch lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
5. Connect the coolant heater cord to the coolant heater.
Notice: The heater cord must not touch the engine, hot pipes, manifold, or any moving parts. Route the cord to the left front of the engine
compartment securing with tie straps as necessary to prevent damage.
6. Fill the cooling system.
