LaCrosse V6-3.8L VIN 2 (2005)
Main Relay (Computer/Fuel System): Testing and Inspection
POWERTRAIN RELAY DIAGNOSIS
CIRCUIT DESCRIPTION
The powertrain relay is a normally open relay. The relay armature is held in the open position by spring tension. Battery positive voltage is supplied
directly to the relay coil and the armature contact at all times. The powertrain control module (PCM) supplies the ground path to the relay coil control
circuit, via an internal integrated circuit, called an output driver module. When the PCM commands the relay ON, the relay coil creates an
electromagnetic field. This electromagnetic field overcomes the spring tension and pulls the armature contact into the stationary contact of the relay
load circuit. The closing of the relay contacts allow current to flow from the battery to the following fuses:
-
The ETC fuse
-
The ELEK IGN fuse
-
The FUEL INJ fuse
-
The O2 SSR fuse
-
The Emission fuse
When the ignition switch is turned to the OFF position, power is interrupted to the output driver module in the PCM, and the relay electromagnetic
field collapses. This action allows the spring tension pulling on the armature to separate from the relay load circuit contact, which interrupts current
flow to the fuses.
If the powertrain relay fails to close, the engine will crank, but will not run. The class 2 communications will be available with the use of a scan tool.
The powertrain relay system diagnosis table assumes that the vehicle battery is fully charged.
TEST
