LaCrosse V6-3.8L VIN 2 (2005)
Oxygen Sensor: Service and Repair
Heated Oxygen Sensor Replacement - Position 2
HEATED OXYGEN SENSOR REPLACEMENT - POSITION 2
TOOLS REQUIRED
J 39194 Oxygen Sensor Wrench
NOTE: The Heated Oxygen Sensor (HO2S) and the Oxygen Sensor use a permanently attached pigtail and connector. Do not remove this pigtail
from the Heated Oxygen Sensor. Damage or the removal of the pigtail or the connector could affect the proper operation of the sensor.
Take care when handling the HO2S and the O2S. Keep the in-line electrical connector and the louvered end free of grease, dirt, or other contaminants.
Also avoid using cleaning solvents of any type. Do not drop the HO2S or the O2S. Do not roughly handle the HO2S or the O2S.
REMOVAL PROCEDURE
NOTE: The oxygen sensor may be difficult to remove when the engine temperature is below 48°C (120°F). Excessive force may damage threads in
the exhaust manifold or the exhaust pipe.
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the heated oxygen sensor (HO2S) electrical connector retaining clip from the HO2S electrical harness connector.
3. Disconnect the HO2S electrical connector from the HO2S electrical harness connector.
4. Use the J 39194 to remove the O2S from the exhaust pipe.
IMPORTANT: Remove the oxygen sensors with the engine temperature above 48°C (120°F). Otherwise the oxygen sensors may be difficult to
remove.
INSTALLATION PROCEDURE
