LaCrosse V6-3.8L VIN 2 (2005)
Alternator: Service and Repair
Generator Bracket Replacement
GENERATOR BRACKET REPLACEMENT
REMOVAL PROCEDURE
1. Turn the ignition OFF.
2. Remove the generator.
3. Remove the coolant inlet pipe lower bolt from the generator bracket.
4. Remove the belt tensioner.
5. Remove the generator bracket bolts.
6. Remove the generator bracket.
INSTALLATION PROCEDURE
1. Install the generator bracket.
2. Install the generator bracket bolts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the generator bracket bolts in the sequence shown.
1. Tighten the generator bracket bolts (1) to 50 N.m (37 lb in).
2. Tighten the generator bracket bolts (2) to 50 N.m (37 lb in).
3. Tighten the generator bracket bolt (3) to 23 N.m (17 lb in).
3. Install the belt tensioner.
4. Install the coolant inlet pipe lower bolt from the generator bracket.
