LaCrosse V6-3.8L VIN 2 (2005)
1. Install the ball stud to the lower control arm.
2. Install the NEW ball stud bolts facing down, away from the ball stud.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the NEW ball stud nuts.
Tighten the NEW ball stud nuts to 68 Nm (50 ft. lbs.).
4. Install the ball stud to the steering knuckle.
5. Install the ball stud castle nut.
Tighten the nut to 20 Nm (15 ft. lbs.) plus an additional 120 degrees.
6. Install a new cotter pin and bend the ends.
7. Install the tire and wheels.
8. Lower the vehicle.
9. Check the wheel alignment.
