LaCrosse V8-5.3L (2008)
3. Install the crankshaft front oil seal (140) onto the J 41478.
4. Install the J 41478 threaded rod with nut, washer, guide, and oil seal into the end of the crankshaft.
5. Using the J 41478, install the oil seal into the cover bore.
1. Use a wrench and hold the hex on the installer bolt.
2. Use a second wrench and rotate the installer nut clockwise until the seal bottoms in the cover bore.
3. Remove the J 41478.
4. Inspect the oil seal for proper installation. The oil seal should be installed evenly and completely into the front cover bore.
6. Install the crankshaft balancer. Refer to Crankshaft Balancer Replacement (See: Cylinder Block Assembly/Harmonic Balancer - Crankshaft
Pulley/Service and Repair).
