LaCrosse V8-5.3L (2008)
1. Apply adhesive GM P/N 12345493 (Canadian P/N 10953488) to the screw.
2. Position the NEW sensors fork to the pin.
3. Rotate the sensor in order to align the sensor locator to the hole in the extension bracket.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
4. Install a NEW brake pedal position sensor bolt.
Tighten the bolt to 2.0 N.m (18 lb in).
5. Connect the electrical connector (2).
Engage the CPA. The CPA will not engage if the connector is not attached properly.
6. Calibrate the sensor. Refer to Brake Pedal Position Sensor Calibration (See: Procedures).
7. Install the I/P insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side (See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Service and Repair).
