LaCrosse V8-5.3L (2008)
9. Remove the seat belt retractor from the lower center pillar.
Installation Procedure
1. Install the belt retractor into the T-slot in the center pillar.
Notice: Refer to Fastener Notice.
2. Install the seat belt retractor bolt.
Tighten the seat belt retractor bolt to 68 N.m (50 lb ft).
3. Position the anchor plate to the seat stud.
4. Install the anchor plate nut to the seat stud.
Tighten the anchor plate nut to 42 N.m (31 lb ft).
5. Install the intermediate guide bolts.
Tighten the intermediate guide bolts to 10 N.m (89 lb in).
6. Install the lower center pillar trim. Refer to Center Pillar Lower Trim Panel Replacement (See: Body and Frame/Interior Moulding / Trim/Trim
Panel/Service and Repair).
