LaCrosse V8-5.3L (2008)
2. Using NEW tie straps and electrical tape, attach the battery current sensor to the battery cable.
2. Install the positive and negative battery cable to the vehicle.
3. Raise and support the vehicle.
4. Install the positive battery cable (2) to the starter motor.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
5. Install the starter solenoid BAT terminal nut (3) to the starter.
Tighten the nut to 10 N.m (89 lb in).
6. Position the positive battery cable boot (4) at the starter solenoid.
7. Install the positive battery cable clip (5) to the transmission stud.
8. Install the battery cable ground (7) to the transaxle stud.
9. Install the transaxle stud nut (8).
Tighten the nut to 30 N.m (22 lb ft).
10. Install the battery cable harness retainers from the engine cradle.
11. Lower the vehicle.
