LaCrosse V8-5.3L (2008)
Quarter Window Glass Moulding / Trim: Customer Interest
Exterior - Quarter Window Molding Delamination
TECHNICAL
Bulletin No.: 09-08-48-005
Date: June 16, 2009
Subject: Rear Quarter Window Molding Finish Deteriorating/Delaminating (Replace Molding Assembly)
Models:
2006-2009 Buick Allure (Canada), LaCrosse
Condition
Some owners may comment that the high gloss finish on the quarter glass molding (applique) is deteriorating (1).
Cause
This condition may be caused by insufficient U.V. protection that may have been applied to the molding. This allows the finish layers to separate,
resulting in a dull, uneven or peeling appearance.
Correction
This procedure is done with the quarter glass assembly on the vehicle. DO NOT remove the glass assembly.
1. Using a plastic trim stick removal tool, pry the molding away from the glass starting at the rear edge (1).
2. With the molding off of the vehicle, remove the seal from the front edge of the molding for reuse.
3. Clean any adhesive residue from the glass assembly using a general purpose adhesive cleaner.