LaCrosse FWD L4-2.4L (2011)
Note: The TPA cannot be removed from the connector while there are terminals present in the connector body.
3. Use a small flat-blade tool to push the TPA until it bottoms out.
4. Use the J-38125-28 tool to release the terminals by inserting the tool into the terminal cavity as shown in the graphic.
5. While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a
terminal out of a connector.
6. Repair the terminal by following the Repairing Connector Terminals (Terminated Lead Repair) (See: Testing and Inspection/Component Tests
and General Diagnostics/General Electrical Diagnostic Procedures/Connector Repairs/Repairing Connector Terminals (Terminated Lead Repair))
Repairing Connector Terminals (Terminal Repair) (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical
Diagnostic Procedures/Connector Repairs/Repairing Connector Terminals (Terminal Repair)) procedure.
Terminal Insertion Procedure
After the terminal is replaced, perform the following procedure in order to insert the terminal.
