LaCrosse FWD L4-2.4L (2011)
Seat Fan: Diagnostic Aids
Probing Electrical Connectors
Probing Electrical Connectors
Special Tools
EL-35616 - Terminal Test Probe Kit
For equivalent regional tools, refer to Special Tools (See: Power and Ground Distribution/Tools and Equipment).
Note: Always be sure to reinstall the connector position assurance (CPA) and terminal position assurance (TPA) when reconnecting connectors or
replacing terminals.
Front probe
Disconnect the connector and probe the terminals from the mating side (front) of the connector.
Caution: Refer to Test Probe Caution (See: Service Precautions/Vehicle Damage Warnings/Test Probe Caution).
Note: When probing female 0.64 terminals, it is important to use the correct adapter. There have been some revisions to the test adapter for 0.64
terminals. The proper adapter for 0.64 terminals is the J-35616-64B which has a gold terminal and a black wire between the base and tip. Failure to use
the proper test adapter may result in damage to the terminal being tested and improper diagnosis.
Note: The proper adapter for probing the terminals for fuses, relays, or diodes in an electrical center is J-35616-35. Using any other tool or adapter may
damage the terminal being tested.
Refer to the following table as a guide in selecting the correct test adapter for front probing connectors:
