LaCrosse FWD L4-2.4L (2011)
5. Install the master cylinder nuts (1) and tighten to 50 Nm (37 lb ft).
6. Connect the brake fluid level indicator switch electrical connector.
7. Install the EBTCM. Refer to Electronic Brake and Traction Control Module with Brake Pressure Modulator Valve Replacement (See: Antilock
Brakes / Traction Control Systems/Electronic Brake Control Module/Service and Repair/Electronic Brake and Traction Control Module With
Brake Pressure Modulator Valve Replacement).
8. Disconnect the power brake booster vacuum sensor electrical connector.
9. Secure the power brake booster vacuum rear pipe to the retainer (1) on the dash panel.
Note: A small amount of denatured alcohol may be used as a lubricant to assist the installation of the power brake booster vacuum sensor.
10. Install the power brake booster vacuum rear pipe and power brake booster vacuum sensor (2) to the power vacuum brake booster.
