LaCrosse FWD L4-2.4L (2011)
6. Hold the threaded shaft of the EN 45680-882 cylinder bore sleeve puller upward in order to retain the shoe alignment to the bottom of the cylinder
bore sleeve.
7. Install the EN 456850-881 fixture (4) onto the threaded shaft of the EN 456850-882 cylinder bore sleeve puller and the engine block.
8. Install the bearing (3) and the nut (1).
9. Tighten the nut (1) to the bearing (3).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
Note: Use 4 old cylinder head bolts for the attaching bolts.
10. Install and tighten the 4 attaching bolts (2) into the cylinder head bolt holes of the block. Tighten the bolts to 15 Nm (11 lb ft).
11. Rotate the nut clockwise in order to remove the cylinder bore liner.
