LaCrosse FWD L4-2.4L (2011)
Note: Ensure that the EN 45680-882 set gauge ring surfaces are clean.
6. Carefully position EN 45680-881 trim tool assembly onto the EN 45680-882 set gauge ring.
7. Loosen the shaft collar screw (2).
8. Push the shaft collar (2) downward using the trim tool preloader (1) until the shaft collar is positioned against the top of the flange bearing (3).
Note: Once this procedure is done, it is not necessary to reset the EN 45680-881 trim tool assembly height until the blades are worn or damaged.
9. Apply downward pressure on the collar and inner drive shaft using the trim tool preloader (1), then tighten the shaft collar screw to 19 Nm (14 lb
ft).
10. Place the EN 45680-881 trim tool assembly onto the cylinder to be trimmed with the directional arrow pointing in line with the crankshaft
centerline and the front of the block.
11. Install the EN 45680-884 4 bolts into the cylinder head bolt holes in the block and tighten to 20 Nm (15 lb ft).
