LaCrosse FWD L4-2.4L (2011)
Note: A drain plug has been provided at the bottom of the water pump assembly for additional coolant drainage from the engine block and water
pump.
4. Drain the coolant from the water pump using the plug at the bottom of the pump.
Note: The water pump holding tool supports the sprocket and chain during water pump service The tool must be used or the balance shaft must be
re-timed.
5. Use the EN-43651 - water pump holding tool (1).
6. Tighten the bolts on the water pump holding tool into the threads on the water pump sprocket.
7. Install the access cover bolts that were removed earlier to secure the water pump holding tool to the front cover assembly.
8. Remove the 3 inner water pump sprocket to water pump bolts.
