LaCrosse FWD L4-2.4L (2011)
Accessory Power Receptacle
1. Ignition OFF, remove the X80 accessory power receptacle - 110 V AC.
2. Test for greater than 1 M ohm between terminal 3 X2 and terminal 3 X1.
‹› If less than the specified range, replace the X80 accessory power receptacle - 110 V AC.
3. Test for less than 3 ohm between the following terminals:
*
The terminal 3 X2 and the applicable receptacle terminal
*
The terminal 3 X1 and the applicable receptacle terminal
‹› If greater than the specified range, replace the X80 accessory power receptacle - 110 V AC.
4. Test for infinite resistance between terminal 1 X1 and terminal 1 X2.
‹› If not the specified value, replace the X80 accessory power receptacle - 110 V AC.
5. Connect an AC powered device to the X80 accessory power receptacle - 110 V AC.
6. Test for less than 3 ohm between terminal 1 X1 and terminal 1 X2.
‹› If greater than the specified range, replace the X80 accessory power receptacle - 110 V AC.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/Verification Tests and Procedures) after completing the diagnostic procedure.
*
120-Volt Accessory Power Receptacle Replacement (See: Service and Repair/120-Volt Accessory Power Receptacle Replacement)
*
Control Module References (See: Testing and Inspection/Programming and Relearning) for control module replacement, setup, and programming
