LaCrosse FWD L4-2.4L (2011)
*
The vehicle is being salvaged for parts to be used on a vehicle with a different VIN, as opposed to rebuilding as the same VIN.
Warning: Refer to SIR Inflatable Module Deployment Outside Vehicle Warning (See: Service Precautions/SIR Inflatable Module Deployment
Outside Vehicle Warning).
1. Lower the driver and passenger windows.
2. Turn the ignition switch to the OFF position and remove the ignition key.
3. Check that all air bags which will be deployed are mounted securely.
4. Remove all loose objects from the front seats.
Warning
A deployed dual stage inflator module will look the same whether one or both stages were used. Always assume a deployed dual stage inflator module
has an active stage 2. Improper handling or servicing can activate the inflator module and cause personal injury.
5. Disconnect the steering wheel air bag yellow connector (1) from vehicle harness yellow connector (3).
Note: If the vehicle is equipped with dual stage air bags the steering wheel air bag and instrument panel air bag will each have 4 wires. Refer to
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name) for determining high and low circuits.
6. Cut the yellow harness connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
7. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.
