LaCrosse FWD L4-2.4L (2011)
1. Install the insulator (3), the bracket (2), on the stabilizer shaft (4).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the bolts (1). Tighten the clamp bolt (1) to 22 Nm(16 lb ft) plus 30 degrees.
3. Install the stabilizer shaft (1) to stabilizer shaft link (2) and tighten to 50 Nm(37 lb ft).
4. Raise the rear support back into position.