LaCrosse FWD V6-3.0L (2010)
15. Remove the electrical harness and the power steering cooler line from the clips in the frame (2).
16. Mark the location of the frame using spray paint for correct positioning during installation.
17. Carefully lower the vehicle until the frame contacts the support table.
18. Remove the frame reinforcements.
19. Remove the two rear frame to body bolts.
20. Remove the two front frame-to-body bolts.
21. Carefully raise the vehicle to separate the frame from the body.
Note: Do not separate the stabilizer bar bracket from the insulator and stabilizer bar when transferring parts.
22. If replacing the frame, transfer components as necessary.
Installation Procedure
1. Carefully lower the vehicle until contacts the frame assembly and is correctly positioned within the spray painted areas.
Caution: Refer to Fastener Caution ().
2. Install the frame retaining bolts then tighten the bolts to 160 Nm(118 lb ft).
3. Install the frame reinforcements then tighten the bolts to 42 Nm(31 lb ft).
4. Remove the mechanics wire and install the steering gear with NEW bolts and tighten to 110 Nm (81 lb ft) plus 150 degrees, plus 15 degrees.
