LaCrosse FWD V6-3.0L (2010)
Keyless Entry Transmitter: Diagnostic Aids
Repairing Connector Terminals
Repairing Connector Terminals
Special Tools
*
EL-38215-10 - Splice Sleeve Crimp Tool
*
EL-35616-D - Terminal Test Probe Kit
*
J 38125-5 - Ultra Torch
*
Terminal Release Tool Kit
For equivalent regional tools, refer to Special Tools (See: Power and Ground Distribution/Tools and Equipment).
Making a Repair with a Terminated Lead or Connector Assembly
1. If using a terminated lead, remove the terminal to be replaced with the appropriate terminal release tool. Refer to the Terminal Release Tool Kit.
2. Cut and strip the wire insulation away from the terminal leaving enough wire length to reassemble the harness and connector without causing
binding or a pinch condition.
3. Crimp the splice sleeve to the terminated lead or connector assembly to the harness wire using the EL-38215-10 - tool. Refer to Splicing Copper
Wire Using Splice Sleeves (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Splicing Copper Wire Using
Splice Sleeves).
4. Use the J 38125-5 - torch to seal the splice.
5. Repeat steps 2-4 if a connector assembly is being used to repair the vehicle.
6. Reassemble the connector and harness.
7. Verify the repair.
