LaCrosse FWD V6-3.0L (2010)
Sunroof / Moonroof Motor: Testing and Inspection
Sunroof Motor/Actuator Initialization/Teach Process (New Motor)
Sunroof Motor/Actuator Initialization/Teach Process (New Motor)
Perform the Initialization/Teach Process any time a new sunroof motor actuator is installed in the vehicle.
"Manual" indicates the first switch detent
"Express" indicates the second switch detent
1. Ensure that the electrical harness on the headliner is connected to the sunroof motor.
2. Put the ignition in the RUN position. (CAL file will be automatically downloaded by Body Control housing, BCM).
"Manual close" is allowed and limited "manual open" is allowed
3. Re-initialization (Normalization) - Press "manual close switch" until glass/roller blind finds hard stop. After initialization "express open" is
allowed but not "express close"
4. Learn:
1. Open the sunroof window/sunshade with the express or manual open the switch to the full open position the release the switch.
2. Press "Manual Open Switch" for more then 10 seconds or until the sunroof window starts AND reaches the Close Position.
5. Verify the operation of the sunroof.
Note: The Initialization/Teach Process is not complete if any of the following actions take place before the initialization cycle is done:
*
The sunroof switch is not held in the close position.
*
The ignition and/or battery power has been removed.
*
The glass panel has not reached the closed position.
The Initialization/Teach Process must be restarted if the procedure is not carried out completely.
