LaCrosse FWD V6-3.0L (2010)
7. Remove the parking brake cable retainer (1).
8. Disconnect the parking brake cable from the actuator lever.
9. Remove the parking brake cable from the cable bracket and position the parking brake cable end aside.
Note:
*
DO NOT use any air tools to remove or install the guide pin bolts. Use hand tools ONLY
*
Install an open end wrench to hold the caliper guide pin in line with the brake caliper while removing or installing the caliper guide pin bolt.
DO NOT allow the open end wrench to come in contact with the brake caliper. Allowing the open end wrench to come in contact with the
brake caliper will cause a pulsation when the brakes are applied.
10. Using a backup wrench to hold the brake caliper guide pin stationary, remove the brake caliper guide pin bolts (1).
11. Remove the brake caliper.
Installation Procedure
