LaCrosse FWD V6-3.0L (2010)
Fuse Block: Diagnostic Aids
Tyco/AMP Connectors (CM 42-Way)
Tyco/AMP Connectors (CM 42-Way)
Special Tools
For equivalent regional tools, refer to Special Tools (See: Tools and Equipment).
Removal Procedure
1. Locate the connector position assurance (CPA) on the connector body and pull the CPA out. The CPA is on the wire harness side of connector.
2. Disconnect the connector from the component.
3. Use a small flat-bladed tool to gently pry off the dress cover by inserting the tool under the cover opposite the harness side and prying up.
4. Remove the cover.