LaCrosse FWD V6-3.0L (2010)
3. Connect a 3 A fused jumper wire between the MIL control circuit terminal 46-X1 and ground. The MIL should illuminate.
‹› If the MIL illuminates, replace the ECM.
‹› If the MIL does not illuminate, test the MIL control circuit for a short to voltage or an open/high resistance. If the MIL control circuit tests OK,
test the cluster ignition circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the IPC\bulb.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests
and Procedures) after completing the diagnostic procedure.
*
Instrument Cluster Replacement (See: Instrument Panel, Gauges and Warning Indicators/Compass/Service and Repair/Instrument Cluster
Replacement)
*
Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming