LaCrosse FWD V6-3.0L (2010)
Transmission Position Switch/Sensor: Service and Repair
6T30/6T40/6T45 - Automatic Transmission
Manual Shift Detent Lever with Shaft Position Switch Assembly Replacement
Special Tools
*
DT-48550 - Detent Lever Pin Remover
*
J-41229 - Manual Shaft Pin Installer
For equivalent regional tools, refer to Special Tools (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Tools and
Equipment/6T30/6T40/6T45 - Automatic Transmission).
Removal Procedure
1. Remove the control valve body. Refer to Control Valve Body Assembly Removal (See: Transmission and Drivetrain/Automatic
Transmission/Transaxle/Service and Repair/Overhaul/6T30/6T40/6T45 - Automatic Transmission/3. Control Valve Body Assembly Removal).
2. Remove the manual shaft detent lever hub pin (1) using DT-48550 - remover.
3. Remove the manual shift shaft pin (5). Discard the pin.
4. Remove the manual shaft (2).
Note: Disconnect the actuator rod (3) from the detent lever assembly. Do not remove the actuator rod from the transmission case.
5. Remove the manual shaft detent (w/shift position switch) lever assembly (4).
Installation Procedure