LaCrosse FWD V6-3.0L (2010)
Note: Do NOT overtighten the thumbscrew. The EN49982-1 - retainer should be able to slide slightly via the slot the screw goes through. This
fore/aft movement will allow easier removal and installation of the chain later.
13. Install EN49982-1 - retainer intake side chain holder onto front cover by screwing in the thumbscrew (2) on the EN49982-1 - retainer finger-tight.
Note: Do NOT tighten the wingnut with a tool of any kind. Firm finger-tightening is sufficient.
14. Tighten wingnut (4) so EN49982-1 - retainer closes over and firmly grasps timing chain.
