LaCrosse FWD V6-3.0L (2010)
5. Insert the EL 38125-553 on a slight upward angle into the cavity below the terminal to be removed. Ensure that the pointed on the end of the tool
is facing the bottom of the terminal and it stays in contact with the terminal until it stops on the plastic terminal retainer.
6. Gently pry the plastic terminal retainer down and carefully pull the terminal out of the connector. Always remember never use force when pulling a
terminal out of a connector. If the terminal is difficult to remove, repeat the entire procedure.
Terminated Lead Repair
1. Remove the terminal.
2. Find the appropriate terminated lead.
3. Use the appropriate splice sleeves depending on the gauge size.
4. Refer to Splicing Copper Wire Using Splice Sleeves (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring
Repairs/Splicing Copper Wire Using Splice Sleeves).
