LaCrosse FWD V6-3.0L (2010)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the negative battery cable terminal and bolt (3) to the left rear cylinder head. Tighten to 25 Nm (18 lb ft).
4. Install the battery positive cable terminal and nut (2) to the starter solenoid. Tighten to 25 Nm (18 lb ft).
5. Install the starter heat shield and tighten to 20 Nm (15 lb ft)
6. Install the battery positive cable terminal and nut (1) to the back of the generator. Tighten to 20 Nm (15 lb ft).
7. Install the battery negative cable terminal (2) and nut (1) to the left front frame rail. Tighten to 25 Nm (18 lb ft).
8. Install the positive battery cable terminal and nut (2) to the battery fuse block. Tighten to 12 Nm (106 lb in).
9. Close battery fuse block cover (1) and install battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (See:
Negative/Service and Repair/Battery Negative Cable Disconnection and Connection).
