LaCrosse FWD V6-3.0L (2010)
Note: The TPA cannot be removed from the connector while there are terminals present in the connector body.
3. Use a small flat-blade tool to push the TPA until it bottoms out.
4. Use the EL-38125-28 tool to release the terminals by inserting the tool into the terminal cavity as shown in the graphic.
5. While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a
terminal out of a connector.
Terminated Lead Repair
1. Remove the terminal.
2. Find the appropriate terminated lead.
3. Use the appropriate splice sleeves depending on the gauge size.
4. Refer to Splicing Copper Wire Using Splice Sleeves (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring
Repairs/Splicing Copper Wire Using Splice Sleeves).
Terminal Replacement Procedure
