LaCrosse FWD V6-3.0L (2010)
Shift Solenoid: Diagnostic Aids
Bosch Connectors (BSK)
Bosch Connectors (BSK)
Special Tools
For equivalent regional tools, refer to Special Tools (See: Power and Ground Distribution/Tools and Equipment).
Terminal Removal Procedure
1. Disconnect the connector from the component.
2. Remove the wire dress cover, if necessary.
3. Push the wire side of the terminal that is being removed toward the connector and hold it in position.
4. Insert the EL-38125-561 tool into the 2 cavities on each side of the terminal at the front of the connector and push until you feel the tool disengage
the terminal retainers.
5. Carefully pull the terminal out of the connector. Always remember never use force when pulling a terminal out of a connector. If the terminal is
difficult to remove, repeat the entire procedure.
Terminated Lead Repair
1. Remove the terminal.
2. Find the appropriate terminated lead.
3. Use the appropriate splice sleeves depending on the gauge size.
4. Refer to Splicing Copper Wire Using Splice Sleeves (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring
Repairs/Splicing Copper Wire Using Splice Sleeves).
