LeSabre V6-231 3.8L VIN 3 SFI (1988)
7.
Tighten bolt/screw (Item 3) while limiting bracket rotation - torque to 55.0 N-m.
8.
Recheck position of bracket and adjust if necessary to ensure good contact against A/C muffler.
9.
Install clamp (Item 4) and tighten to 5.6 N-m.
IMPORTANT:
After installation is completed, check engine/transmission mounts for separation and check engine for excessive vibration in the
1200 to 1500 rpm range. Correct as required.
Parts are expected to be available on March 15, 1989. Until then, normal part orders will not be accepted bv GMSPO. Only verifiable emergency VIP
orders will be accepted. SPO will make every effort to obtain parts. All parts will be placed on 400 control to waive VIP surcharges. However, the part
will be shipped premium transportation at dealers expense. All other order types will be cancelled as incorrectly ordered while the 400 control is in
place.
