LeSabre V6-231 3.8L VIN B FI (1986)
FIGURE 1 - FUEL TANK HANGER STRAP ASSEMBLY
NOTE:
Some early 1985 Electras may have soft compressible white or hard asbestos type insulation strips. If this is the case, remove them and use two
additional 1" x 24" strips from a second kit.
Then lay a second new 1" x 24" insulator strip from the kit part number 22530899, over each of the original ones so as to double strip each cavity
insulator strip, without cutting off the area over the drain plug (See Figure 1).
4.
Remove the pads from both seat belt anchor protrusions and reinstall the 2" x 6" pad on the right seat belt anchor protrusion and the 2" x 2" along
with one new 2" x 2" from the kit on the left seat belt protrusion. Secure pads in place with duct tape (See Figure 1).
