LeSabre V6-231 3.8L VIN C SFI (1990)
![background image](/buick/lesabre/v6-231_3.8l_vin_c_sfi/Page-1746002.png)
When the brakes are initially applied, the metering valve stem moves to the left, preventing fluid to flow through the valve to the front disc brakes.
This is accomplished by the smooth end of the metering valve stem contacting the metering valve seal lip at 4 to 30 psi, Fig. 9. The metering valve
spring holds the retainer against the seal until a predetermined pressure is produced at the valve inlet port which overcomes the spring pressure and
permits hydraulic pressure to actuate the front disc brakes, Fig. 10. The increased pressure into the valve is metered through the valve seal, to the front
disc brakes, producing an increased force on the diaphragm. The diaphragm then pulls the pin, in turn pulling the retainer and reduces the spring pressure
on the metering valve seal. Eventually, the pressure reaches a point at which the spring is pulled away by the diaphragm pin and retainer, leaving the
metering valve unrestricted, permitting full pressure to pass through the metering valve.
Fig. 11 Failure Warning Switch. Rear System Failure
Failure Warning Switch
If the rear brake system fails, the front system pressure forces the switch piston to the right, Fig. 11. The switch pin is then forced up into the switch,
completing the electrical circuit and activates the dash warning lamp.
When repairs are made and pressure returns to the system, the piston moves to the left, resetting the switch. The detent on the piston requires
approximately 100 to 450 psi to permit full reset of the piston. In event of front brake system failure, the piston moves to the left and the same sequence
of events is followed as for rear system failure except the piston resets to the right.
Fluid Level Sensor
This sensor mounted on the master cylinder will activate the Brake Warning lamp if a low brake fluid level is detected. The lamp will turn off once the
fluid level is corrected.
Fig. 12 Proportioner. Rapid Deceleration