LeSabre V6-231 3.8L VIN C SFI (1990)
Condenser HVAC: Service and Repair
TOOL REQUIRED
J 38042 Dual O-Ring Joint Separator (or equivalent)
CAUTION: Brazed fittings are on the condenser and evaporator. These fittings cannot be turned because the fitting is brazed to the pipe. It is
important that the service technician recognize which fitting is to be turned and use backup wrenches. The brazed fitting not to be turned is always the
same color as the pipe it is brazed to (unpainted or unplated aluminum).
REMOVE OR DISCONNECT
1. Recover refrigerant from A/C system, Refer to Refrigerant Recovery and Recycling. See: Service and Repair
2. Battery hold down and battery.
3. Air cleaner attaching bracket screw.
4. Lines from auxiliary transmission cooler (if equipped).
5. Upper radiator panel bolts and panel.
6. Condenser inlet and outlet lines.
7. Mounting bracket bolts and brackets.
8. Upper insulators.
9. Condenser by tilting radiator toward engine.
INSTALL OR CONNECT
1. Condenser into position by tilting radiator toward engine.
2. Upper insulators.
3. Mounting brackets and bolts.
^
Tighten Bolts to 6 Nm (53 lb. in.).
