LeSabre V6-231 3.8L VIN L SFI (1992)
1. Assure the nut holding the outer molding at the rear is tight and the front clip is properly located behind the impact bar. (See figure 2) Some
movement in this molding is normal.
2. Assure the fascia is even across the front of the vehicle by measuring the gap between the turn signal and the fascia (see page 1-2-14 in the 1993
Service Manual). To adjust the height of the fascia, loosen the four (4) impact bar attaching nuts (see figure 3) on each side and adjust as
necessary. Observe the changes in the fascia to bright bar gap as the fascia is moved. In some cases, the gap or bulge will be corrected by changing
the height. Assure the fascia is centered (see step 3) prior to re-tightening the impact bar attaching nuts. Also, assure the bright bar is properly
aligned to the outer molding on the side of the fascia. (See Figure 1)
3. Assure the fascia is centered right to left by checking in the following two areas: