LeSabre V6-231 3.8L VIN L SFI (1992)
Rear Bumper Cover / Fascia: By Symptom
Bumper - Rear Facia Lower Edge Wavy
Bulletin:
93-2-1
Date:
Nov. '92
Ref.No.:
93-26-2
Corp.Ref.No.:
202002
SUBJECT:
REAR FASCIA LOWER EDGE WAVY
MODELS AFFECTED:
1992-93 LESABRE
CONDITION:
Some of the 1992-93 LeSabre models may exhibit a wavy appearance on the rear fascia lower edge.
CORRECTION:
To correct this condition, a molding kit, part number 25616605 has been released. The kit includes five (5) parts of three (3) different lengths. The
different lengths are necessary due to the retaining tabs on the fascia.
Begin by installing the shortest molding (125 mm or approximately 5 inches) in the center of the fascia. On either side of the center molding, install the
next shortest moldings (175 mm or approximately 6-7/8 inches) just past the fascia retaining tabs. The remaining moldings are then installed between the
outboard fascia retaining tabs. (see illustration).
Parts are currently available from GMSPO.
WARRANTY INFORMATION:
Labor Operation No.: T5333
Labor Time: 0.2 hr.
