LeSabre V6-231 3.8L VIN L SFI (1992)
from the surface. This is necessary so that a free space is provided to allow the air bag to expand in the unlikely event of accidental deployment.
Failure to follow procedures may result in personal injury.
6.
Clear a space on the ground approximately 185 cm (six feet) in diameter where the fixture with attached inflator module is to be placed for
deployment. A paved outdoor location where there is no activity is preferred. If an outdoor location is not available, a space on the shop floor
where there is no activity and sufficient ventilation is recommended. Ensure that no loose or flammable objects are within the deployment area.
7.
Place the J 39401 on the ground in the space cleared in step 6, if it has not already been placed there. Refer to Figure 2.
8.
Fill plastic reservoir in fixture with water or sand. This is necessary to provide sufficient stabilization of the fixture during deployment.
