buick Workshop Repair Guides

Buick Workshop Service and Repair Manuals

83-64-09|Page 5109 > < 83-64-09|Page 5107
Page 1
background image

Alternator: All Technical Service Bulletins
Headlamps/Windshield Wipers - Dim/Slow Operation

File In Section: 6 - Engine

Bulletin No.: 53-64-01

Date: March, 1995

Subject:
Dim Headlamps, Slow Windshield Wipers, etc., Resulting from Low/No Generator Output (Retrofit with CS-144 Generator)

Models:
1992-94 Buick LeSabre, Park Avenue
1992-94 Oldsmobile Eighty Eight, Ninety Eight
1992-94 Pontiac Bonneville

CONDITION
Some owners may comment on such conditions as dim headlamps, slow windshield wipers, etc. After testing, it is confirmed that the generator has low
or no output.

CAUSE
In some high temperature applications, it has been determined that the CS-130 and CS-130 Dual Internal Fan (DIF) generators cannot perform with
reliability to meet owner expectations.

CORRECTION
The CS-144 retrofit has been devised to increase durability and performance.

Replace the following components:

1.

The CS-130 and CS-130 DIF generators with the 140 amp CS-144 generator, P/N 10463625.

Important:

The CS-144 generators listed above will include: the output terminal plastic cap, P/N 3523277, and the output terminal nut, P/N 11502811.
These parts can be ordered from GMSPO if they are not with the generator.

2.

The regulator connector, P/N 12117361, (for vehicles equipped with CS-130 DIF generator only).

3.

The positive battery cable/generator output wire assembly with P/N 12164880 (on models with L27 engine) and P/N 12164881 (on models with
L67 engine).

4.

The accessory drive belt with P/N 24504258 (on models with L27 engine) and P/N 24504257 (on models with L67 engine).

REPLACEMENT

1.

Replace battery cable/generator output wire assembly. Refer to Section 6D1 in the appropriate Service Manual for battery cable replacement. Be
sure to note the routing of the cable.

2.

Replace regulator connector (CS-130 DIF generator only). Refer to Section 8A in the appropriate Service Manual for wiring, splicing procedures.

Important:

Note the number and location of wires on the CS-130 DIF connector. The only wire required for the CS-144 connector is the "L" terminal
wire. The remaining wires should be taped off and positioned away from any moving components.

3.

Replace CS-130 (or CS-130 DIF) with a CS-144 generator. Refer to Section 6D3 in the appropriate Service Manual for generator replacement.

4.

Replace the generator drive belt. Refer to Section 6A8 in the appropriate Service Manual for drive belt replacement.

PARTS INFORMATION
Parts are currently available from GMSPO.

WARRANTY INFORMATION
For vehicles repaired under warranty, use: 

Labor
Operation

Labor Time

83-64-09|Page 5109 > < 83-64-09|Page 5107